Home>Modified Accessories>Muzzle>DK 9.5mm*13mm Hopup for Gel Ball Blaster
DK 9.5mm*13mm Hopup for Gel Ball Blaster

DK 9.5mm*13mm Hopup for Gel Ball Blaster Item NO.: 2634293

AU$ 8.63 ~ AU$ 11.50
Quantity 1-1 2-5 6-20 21-100
Discount 0% OFF 10% OFF 20% OFF 25% OFF
Price AU$ 11.50 AU$ 10.35 AU$ 9.20 AU$ 8.63

Copy and share this link on social network or send it to your friends

Product Name DK 9.5mm*13mm Hopup for Gel Ball Blaster
Item NO. 2634293
Weight 0.05 kg = 0.1102 lb = 1.7637 oz
Category Modified Accessories > Muzzle
Tag hop up
Creation Time 2019-03-02

DK Reverse Thread Hop Up with 9.5mm Inner Diameter 13mm Outer Diameter for Reverse Thread Cap

.This product is adjustable friction Hop Up, 9.5mm outer diameter accurate barrels is available.
.When installing, first unplug the original muzzle, then insert the Hop Up into the bottom so that the exhaust slot is facing down and the adjusting screw is facing up.
.Rotate the Hop Up screw with the included hex wrench to adjust the angle of the Hop Up rotation to adapt to the water gel beads b of different sizes and hardness. When screwing the screw, please carefully screw it to prevent damage to the Hop Up.
.It is recommended that the water gel beads size be 7.0-7.4mm. When using the digital caliper, measure the diameter of the water gel beads. When it reaches 7.2mm, you can fish it out. The water gel beads over the assembly, and the friction plate is too low to adjust the position.
.After the water gel beads are good, the water must be drained and reused, or the water should be dried over the towel. Otherwise, the surface of the projectile will have too much moisture, which will weaken the effect of the Hop Up friction and cause the urine bomb.
.The Hop Up accurate barrels connection is 9.2mm and only fits the original plastic accurate barrels.
.The principle of 3D printing is layer-by-layer manufacturing, which will inevitably produce lines and seams. This is a normal phenomenon, non-quality problems, all shipments after passing the inspection are guaranteed, and the inner wall is free of burrs.
.The ABS plastic, which is printed on the Hop Up, is far more resistant to temperature than PLA, and there is no need to worry about heat deformation in summer.
.Adaptation: 9.5mm outer diameter accurate barrels and 13mm reverse thread cap
.Color: As Shown
.Material: ABS
.Product Dimensions: 4*1.3*1.3cm
.Product Weight: 30g
.Package Dimensions: 4*2*2cm
.Package Weight: 50g
.Packing: Box
Package Content:
.1 x Hop Up

No related record found